SKU: IPYPA984750AA

International Primocon Antifouling – Underwater Primer 750ml

Primocon is a grey, tar-free, quick drying, conventional primer for all substrates underwater. Also suitable as a barrier/sealer coat over incompatible or unknown antifoulings.

Can be used under all International antifoulings. Not suitable to be overcoated with 2-component solvent-based paints.

  • Area: Below the waterline
  • Finish/Sheen: Matt
  • Thinner/ Cleaner: YTA085 Thinners No.3
  • Number of Coats: 1-5 by brush or roller depending on the substrate.
  • Method of application: Brush, Roller or Airless Spray.

Preparation: Note: Wash all substrates except STEEL

WOOD: Sand with 80-180 grade paper. Pre-prime with Primocon thinned 10-15% with thinners no.3 (15-20% for oily woods).

PLYWOOD: Sand with 80-280

BARE GRP: Sand with 180-220 grade paper.

LEAD: Rub down with an emery cloth or power wire brush. Degrease and Pre-prime with Etch Primer
.
STEEL: Grit blast SA2.5 to 3. Use an angle grinder on small areas. Pre-prime with Primocon thinned 10-15% with thinners no.3.

ALUMINIUM: Mechanically abrade with aluminium compatible sandpaper or low pressure grit blast using aluminium oxide. Pre-prime with Etch Primer
.
ZINC/GALVANISED STEEL: Pre-prime with Etch Primer

PREVIOUSLY ANTIFOULED SURFACES: In good condition Remove any loose or flaking material. Rinse with fresh water and allow to dry. In poor condition: Antifouling should be completely removed with Interstrip.

£28.54

Weight 1 kg

Description

Primocon is a grey, tar-free, quick drying, conventional primer for all substrates underwater. Also suitable as a barrier/sealer coat over incompatible or unknown antifoulings.

Can be used under all International antifoulings. Not suitable to be overcoated with 2-component solvent-based paints.

  • Area: Below the waterline
  • Finish/Sheen: Matt
  • Thinner/ Cleaner: YTA085 Thinners No.3
  • Number of Coats: 1-5 by brush or roller depending on the substrate.
  • Method of application: Brush, Roller or Airless Spray.

Preparation: Note: Wash all substrates except STEEL

WOOD: Sand with 80-180 grade paper. Pre-prime with Primocon thinned 10-15% with thinners no.3 (15-20% for oily woods).

PLYWOOD: Sand with 80-280

BARE GRP: Sand with 180-220 grade paper.

LEAD: Rub down with an emery cloth or power wire brush. Degrease and Pre-prime with Etch Primer
.
STEEL: Grit blast SA2.5 to 3. Use an angle grinder on small areas. Pre-prime with Primocon thinned 10-15% with thinners no.3.

ALUMINIUM: Mechanically abrade with aluminium compatible sandpaper or low pressure grit blast using aluminium oxide. Pre-prime with Etch Primer
.
ZINC/GALVANISED STEEL: Pre-prime with Etch Primer

PREVIOUSLY ANTIFOULED SURFACES: In good condition Remove any loose or flaking material. Rinse with fresh water and allow to dry. In poor condition: Antifouling should be completely removed with Interstrip.

Shopping Cart